Services

Repair Services
Full range of services for all types of bicycles.
Anything that can be adjusted, repaired, straightened, trued, or replaced on a bike,
The Bicycle Garage' does it - as well as frame & fork repair or modification.
Typically 1-2 days to complete service with scheduled appointments,  3+ without.

*    Services that are not included with a Tune-up or Overhaul may be discounted up to 15% when
performed at the same time as Tune-up or Overhaul.
**   With the purchase of a complete bike, build is included.
Frameset only build may be discounted up to 15%.
Build Kit only build may be discounted up to 15%.
For fittings on bikes not purchased from us: Parts swaps are extra

Pay your Service Invoice
Pay a Deposit
© 2008 MSH1 Bicycle Works™
Tune-up **
$49
Includes adjustment and lubrication of all components, adjustment of
all bearings, cleaning and lubrication of drivetrain.
 
Overhaul **
$99
Includes removal, cleaning, lubrication of all components,
disassembly, cleaning, lubrication, and reassembly of all bearings.
Includes Tune-up.
 
Common Services *
 
Replace Tube or Tire
$8
Replace UST tire & sealant
$18
Install Bike Computer
$12
Replace Tubular Tire & Glue
$20
Adjust Front / Rear Brake
$6 / $8
Adjust Front / Rear Derailleur
$6 / $8
Replace Pedals
$5
Adjust Wheel Hub
$8
Adjust Bottom Bracket
$8
Adjust Headset   
$8
Replace Front / Rear Brake Cable  
$8 / $10
Replace Brake Pads (2 pads, includes adjustment)
$8
Replace Disk Brake Pads (1 set, includes adjustment)
$15
Replace Front / Rear Derailleur Cable   
$8 / $10
Overhaul / Install / Replace Headset  
$22 / $12 / $18
Replace Freewheel / Cassette
$10 / $10
Replace Chain (Pinned / Quick-link)
$10 / $8
True Wheel
$10
Replace Front Wheel Spoke
$3
Replace Rear Wheel Spoke (non-drive side / drive side)
$5 / $8
Overhaul / Install / Replace Bottom Bracket
$22 / $18 / $20
Overhaul Front / Rear Wheel Hub
$14 / $16
Build Wheel / Rebuild Wheel (Prospoke™ handbuilt wheels)
$45 / $50
Rim Swap & True
$30
Additional Services *
 
Bike Build (boxed bike) Assemble & Tune - typically new bikes, bikes
returning from travel, or shipped bikes.
$49
New Bike Complete build & tune from bare frame, new components
(cut / route / lube cables, install bar, stem, post, saddle, bar tape, rim
strips, tubes&tires, derailleurs, chain, headset, BB, brakes, shifters,
wheels, pedals, setup cockpit **
$159
Frame Swap (remove components from old frame + new frame
complete build) **
$179
Bike Quickfit **
$15
Full Bike Fitting + Body Measurement + Bike Setup & Adjustment  +
Ergonomic Assessment **
$69
Dropout / Derailleur Hanger Straightening & Alignment
$8 / $10
Install Replaceable Derailleur hanger
$8
Cut Steerer Tube (metal / carbon)
$10 / $14
Chase BB Threads / Face BB shell / Machine headtube / Machine
crown race
$20 / $18 / $30 / $25
Cut down Handlebars to length
$10
Handlebar Swap - Road drop bar / MTB flat or riser bar
$20 / $16
Stem Swap - Road Drop bar
(single bolt clamp / double bolt cap clamp)
$18 / $8
Replace STI combo Shifter & Brake Levers  (Road / MTB) - Left &
Right Levers
$30 / $25
Replace Handlebar mounted Shifter only - MTB Left & Right Shifters
$18
Replace Down Tube Mounted Shifters - Left & Right Shifters
$12
Replace Brake Levers (Road / MTB)
$25 / $16
Stem Swap - MTB bar
(single bolt clamp / double bolt cap clamp)
$14 / $8
Install / Replace Handlebar Tape - Road Drop bar
$8 / $10
Install / Replace Handlebar Grips - MTB bar
$3 / $5
Install Bike Rack
$8
Install Fenders (Front & Rear)
$12
Hydraulic Brakes (adjust, replace, bleed, etc.)
Contact Us
Any other service inquiry not listed here
Contact Us
Solution Graphics

Pricing
Prices are subject to change without notice.
Some jobs may vary due to difficulties extracting rusted and seized parts.

Hourly Shop Rate: $48/hour
Shop rate may apply to milling, facing, reaming and other cutting jobs, and for frame /
fork / dropout alignments; fixed rates for these services as listed in table above apply to
frames that require little prep / disassembly time, as in a new bare frame.
Services not listed above may be charged at the hourly rate.
Service in excess of the standard rates, such as rusted or seized parts, requiring
additional time will incur additional charges based on the hourly rate.
Consultation services, or custom services may be charged at the hourly rate.
Repeat customers usually will receive a loyalty discount, assessed on a per-job basis.

Scheduling
Some minor repairs and tube installation can be done on a “while-you-wait” basis.  Most
services, including tune-ups, require that your leave your bike.
Turnaround times as stated at top of this page.
Next-day service is available for scheduled service appointments.  Call or email our
service department to schedule your appointment.

Warranty
We offer a 30-day warranty on labor. Parts carry original manufacturers warranty. Contact
us if  manufacturers warranty assistance is required.
New bikes (frame + build kit) purchased from us include a 1-year service warranty.

Deposits
Minimum 25% deposits are customary where parts total more than $100, and/or
services total more than $150.  We reserve the right to require a deposit in any
circumstance.

Remote Repair Service
"Mail-order" or remote service repairs (i.e. where you ship us your hardware) require a
minimum flat rate administration fee of $25 due to the additional overhead time required
to administer this service. Customer pays all shipping cost.

Pickup Service
Pickup and return service available (approx. 30 mile radius).
View Pickup & Delivery Service Coverage Area

"Ask Matt"
Submit your question here.

Consulting Services (Fees may apply)
1. Beginner Level -  the person who is new to cycling who wants to learn
basic riding technique, safety, bike handling, what bike to buy, what to
wear, where to ride, etc.
2. Intermediate Level -  the person who wants to expand beyond basic
cycling, advanced skills, training methods for specific goals.
3. Advanced Level  - training technique, nutrition for fitness, coaching,
cross training, seasonal intensity, peaking/tapering, racing

The individual is interviewed to assess past, present and future cycling goals,
and gather information regarding history, and current fitness level.  A complete,
well-rounded individually customized evaluation package is generated based
on Target Level (Beginner, Intermediate, Advanced)  and the individual's needs
and wants. The evaluation package can include information such as the
following (based on what the individual requires) riding routes, clothing/how to
dress, bicycle fit/riding position, bicycle repair/maintenence training, bicycle
selection, cross training, weather challenges, motivation technique,
developing goals/planning training, accessories equipment (e.g. bike
computers, heart rate monitors, GPS), nutrition.
The Bicycle Garage
Services